Humidifier package contains:

1 600 cc Humidifier

1 4ft clear air hose.

1 18” corrugated (blue) tubing.

1 nylon air nipple.

1 2” nylon adapter

1 Nebulizing door panel.

Directions for use:

Install the nylon air nipple into the top of the humidity bottle (air inlet).

Take caution, not to over tighten.

Connect one end of the clear air hose to the nylon air nipple, and the other end to an air source,

either air compressor or oxygen.

Fill the bottle with water (tap, sterile, or distilled) by unscrewing the top, or by pulling out one of the plugs on top.

Attach the large corrugated (blue) tubing to the outlet stem on the side of the humidity bottle then connect the other end to the nylon adapter in the door panel.

Tighten cap securely to the bottle, and /or replace the plugs snugly into the cap in order to provide an effective seal.

Note: The “dial” (entrainment) around the inlet stem show the percentage of oxygen and “not” the percentage of humidity. Adjust the entrainment dial around the inlet stem to the proper percentage of oxygen desired. The numbers on the dial give oxygen percentage concentration available. The proper percentage marks is adjusted to the indictor mark on the front of the inlet stem above the dial (the higher the number the higher percentage of humidity).